Aluminium elbows let you route pipework around obstacles without choking the flow through it. Our range covers 45°, 90°, 135° and 180° bends in outside diameters from 13mm to 102mm, so you can plan a run around an engine bay, a bulkhead or a machine frame and still hold a consistent bore from end to end.

Each elbow is formed from high-grade T6063 aluminium with a 1.6mm wall. That gives you the strength to take clamping loads and boost pressure while staying far lighter than an equivalent steel bend, and the alloy's natural corrosion resistance means no coating to chip or flake in service. The bend itself is formed rather than cut and welded, so the internal surface stays smooth and the cross-section stays round through the radius — the flow does not see a step or a weld seam.

Both ends are beaded. The raised lip gives a silicone or rubber hose something positive to grip, and stops a joint blowing off under pressure once a clamp is tightened over it. Match the elbow's outside diameter to your hose's internal diameter, add the appropriate hose clamp, and the joint will hold.

Commonly used in intercooler and charge pipework, cold air intakes, coolant routing, ventilation and air handling, and general industrial fabrication where a light, corrosion-resistant bend is needed.